Window Pass Through Cable SMA: 45cm Low Loss Coaxial, SMA RP Male to N Female

Window Pass Through Cable SMA: 45cm Low Loss Coaxial, SMA RP Male to N Female

A window pass through cable SMA is a short, flat-profile coaxial lead that carries the signal from an indoor LoRaWAN hotspot to an outdoor antenna without drilling a hole. The 45cm version with an SMA RP male plug on one end and an N female socket on the other is a common choice for Helium miners placed right behind a window.

Window pass through cable SMA with 45cm low loss coax carrying signal from an outdoor antenna through a closed window

What this 45cm cable actually does

The SMA RP male end plugs into the miner. The N female end takes an outdoor antenna, usually a fiberglass omni with an N male connector. In between, a low loss coaxial run of 45cm sits flat against the glass frame.

Short matters. At 868 MHz (the EU Helium band) a thin RG174 style lead can lose around 0.8 to 1 dB per metre, so a 45cm piece costs well under 1 dB. Longer thin cables waste far more. Every dB lost on the way out also hurts on the way back, which is what reduces witness range.

How a window pass through cable SMA works

Most window cables have a flattened section about 1 to 2 mm thick in the middle. You close the window or door onto it, and the rubber seal absorbs the thickness. Some designs are a two-piece lead with a thin flat bridge between two round cable ends.

Check the seal after closing. If you can feel a draught, add a strip of self-adhesive foam tape along the frame. Avoid pinching a round cable, because crushing the shield changes the impedance and can wreck the signal.

SMA RP, SMA and N: avoiding connector mistakes

This is where most returns happen. A plain SMA plug has a centre pin. An SMA RP (reverse polarity) plug has the pin missing on the male side and a socket inside the thread. They look almost identical and do not mate.

Look at your miner. If the antenna port on the device has a centre pin, it needs an RP male cable. Many hotspot models use this, but verify against the manual before anything else.

  • SMA RP male: goes on the miner side
  • N female: takes the outdoor antenna
  • Impedance: 50 ohm throughout

Choosing the right length

For a hotspot sitting on a windowsill, 45cm is usually enough. If the miner has to sit on a shelf or desk further in, look at the 50cm window pass-through cable as a slightly longer alternative. Five centimetres sounds trivial, but it can decide whether the lead reaches without strain on the connector.

Anything beyond about 1 metre calls for a thicker cable type such as LMR240 or LMR400 style, which loses less per metre. A flat window lead is not meant for long runs.

Fitting tips for the Helium antenna window cable setup

If you want the broader picture on routing and sealing, the Helium antenna window cable topic covers the options. Some practical points for this particular lead:

  • Hand-tighten connectors, then give the N connector a quarter turn with a spanner at most
  • Wrap outdoor N joints in self-amalgamating tape, then a layer of vinyl tape, to keep water out
  • Leave a drip loop so rain does not run down the cable into the joint
  • Mount the antenna as high as the mast or bracket allows, ideally 1 to 2 metres above the window

Never power the miner without an antenna attached. A transmitter running into an open port can damage the radio.

What does the 45cm SMA male to N-female lead cost?

Expect roughly 8 to 15 EUR for a decent unit, as an indicative range. Very cheap leads under 5 EUR often skimp on shielding. Gold-plated connectors are nice but matter less than a properly crimped, well-shielded cable body.

The 45cm SMA male to N-female format is the one to look for when your miner uses a standard SMA plug rather than RP, so double check the pin before comparing listings.

Frequently Asked Questions

Will a window pass through cable damage my signal?

The flat section adds a small extra loss, typically 0.2 to 0.5 dB at 868 MHz. Total loss on a 45cm lead stays around 1 dB or less. For indoor-to-outdoor placement, that is far better than leaving the antenna behind glass, which can cut signal by several dB.

Can I use it with double glazing?

Yes, as long as the frame seal is soft enough to take the flat section. Uneven or very stiff seals may leave a gap. Tape a thin foam strip around the cable to close it.

Is SMA RP the same as SMA?

No. The two share the same thread but have the pin and socket swapped, so they will not connect properly. Check the connector on your miner first, and match it with the correct cable end.

Can I extend the cable with another lead?

You can join two leads with an adapter, but each connection adds around 0.1 to 0.3 dB of loss. It is better to use one cable of the right length, or a thicker low loss cable for anything over a metre.

Is this suitable for outdoor use?

The cable body handles brief exposure, but the connectors are not waterproof by themselves. Keep the miner inside, weatherproof the N joint, and avoid leaving long stretches of the thin cable in direct sun and rain.