Helium Antenna Shop: How to Pick the Right Antenna and Cable
If you are browsing a Helium antenna shop, the first thing to settle is gain, not looks. For EU868 LoRaWAN hotspots, most owners end up between 3 dBi and 8 dBi, and the right number depends on terrain, height and how much cable sits between the radio and the antenna.
This page explains the choices that matter: gain, polarization, cable loss, mounting position and connectors. Nothing here is a sales offer. It is a plain guide to help you compare what you find elsewhere.
Antenna gain: what the numbers really mean
Gain describes how the antenna focuses energy. A higher figure squeezes the signal into a flatter, wider disc around the antenna. You gain range along the horizon and lose coverage above and below.
Stock antennas supplied with hotspots are usually around 2 to 3 dBi. They work fine in a dense town where you want to reach sensors on upper floors. In open countryside, flat and low, they leave range on the table.
- 3 to 5 dBi: hilly areas, apartment blocks, tall buildings nearby.
- 6 to 8 dBi: suburbs and flat terrain, mast or roof mounting.
- 9 to 12 dBi: very flat open land only, with the antenna well clear of obstacles.
A well-placed 8 dBi unit can reach devices roughly 5 to 10 km away in clear line of sight, while a short stock antenna indoors may manage a few hundred metres through walls.
Outdoor options for EU 868 MHz
The frequency band matters. Europe uses 863 to 870 MHz, so an antenna tuned for 915 MHz (US) will be mismatched and waste signal. Check the label for 868 before anything else.
A popular middle ground is an 8 dBi outdoor antenna, a fibreglass collinear that handles rain, frost and UV for years. It needs a clear mast or wall bracket and a vertical position, since tilting it shifts the radiation pattern.
If your site is very flat and open, a 10 dBi helium antenna gives a little more horizontal reach. The trade-off is a narrower vertical beam, so nearby devices above or below it may drop out. I would not go above 8 dBi in a town.
Cables, losses and the window problem
Cable eats signal. Thin RG174 loses around 0.8 dB per metre at 868 MHz, so a 5 m run can swallow 4 dB, which cancels most of a gain upgrade. LMR-400 style cable loses about 0.2 dB per metre, far better for longer runs.
Rule of thumb: keep the cable short, and mount the antenna as high as practical. A 3 dBi antenna on a roof often beats an 8 dBi unit behind a double-glazed window.
Getting a signal outside without drilling
Many renters cannot drill through walls. A Helium antenna window cable is a flat, thin lead that passes under a closed window seal, so the antenna sits outside while the hotspot stays dry indoors. A Window pass-through SMA cable does the same job with SMA connectors at each end, which suits most LoRaWAN miners directly.
Flat cables are usually short, often 1 to 3 m, and they lose more per metre than coaxial. Use them only for the crossing, then keep the rest of the run minimal. Check that the window still closes without crushing the cable, because a pinched lead can break inside.
Connectors and adapters
Most hotspots use SMA female or N-type sockets, and mixing them up is the most common buying mistake. Look at the pin inside the plug: SMA and reverse-polarity SMA look nearly identical but do not mate.
Every adapter adds about 0.1 to 0.3 dB of loss and one more place for water to get in. Wrap outdoor joints with self-amalgamating tape, then add a layer of vinyl tape over it.
Mounting and placement tips
- Keep the antenna at least 1 m from metal surfaces and gutters.
- Place it vertically, never lying flat.
- Add a lightning arrestor if the mast is the highest point nearby.
- Leave a drip loop in the cable before it enters a building.
Height beats gain nearly every time. Moving an antenna from 3 m to 10 m can change coverage more than going from 5 dBi to 8 dBi.
Frequently Asked Questions
What antenna gain is best for a Helium hotspot in Europe?
For most homes, 3 to 6 dBi gives balanced coverage. Go to 8 dBi only if the terrain is flat and the antenna is mounted outdoors, high and clear of obstacles.
Can I use a 915 MHz antenna on EU868?
It will transmit, but poorly. The mismatch raises reflected power and shortens range, so buy an antenna marked for 868 MHz.
How long can the antenna cable be?
With low-loss coax, up to 10 m is workable, costing about 2 dB. With thin cable, stay under 3 m or the loss outweighs any gain from a bigger antenna.
Do I need a lightning arrestor?
It is wise for any antenna on a mast or roof peak. Arrestors cost roughly 10 to 25 EUR and need a proper earth connection to work.